Buffalo Tools MT43CC, Инструкция по эксплуатации

Страница: 7 / 19

7
SAFETY DECALS
Reading this manual and the safety instructions it contains will provide you with the necessary basic knowledge to oper-
ate this equipment safely and effectively. We have placed a safety decal on the cultivator to remind you of some of this
important information while you are operating the unit.
Familiarize yourself with the location and content of the safety messages you will see as you perform normal
cultivating operations. Please review this decal (above). If you have any questions regarding its meaning or how to
comply with these instructions, reread the complete safety instruction text in this manual, or contact your local dealer.
Should this decal become unreadable because of being worn, faded, or otherwise damaged during the use of your
cultivator, please use the part number information provided to order a replacement label from customer service. These
decals are easily applied, and will act as a constant visual reminder to you, and others who may use the equipment, to
follow the safety instructions necessary for safe, effective operation of your cultivator.
UNPACKING & ASSEMBLY
UNPACK CULTIVATOR
1. Carefully lift the cultivator out of the box, remove any packing material and cut any ties holding the handlebar pieces to
the cultivator assembly.
ASSEMBLY
1. Stand the cultivator assembly upright with tines and wheels on a level surface. Wheels should be set in the lowest
position.
DO NOT place the cultivator on a high surface where it can fall and cause property damage or personal
injury.
2. Using two tee handle nuts, two bolts, and two curved washers, assemble the middle handlebar to the lower
handlebar that is already attached to the cultivator assembly. The middle handlebar can be installed in two positions
one high and one low.
DO NOT overtighten the tee handle nuts.
3. Attach the upper right and left handlebars to the middle handlebar using the two remaining tee handle nuts, bolts, and
curved washers.
DO NOT overtighten the tee handle nuts.
4. The drag stake is shipped with point facing upwards. Before using, remove detent pin and turn the drag stake
around so the point is directed in the downward position facing towards the tines. Re-insert detent pin.