Buffalo Tools MT43CC, Инструкция по эксплуатации

Страница: 10 / 19

10
3. Move choke lever to CHOKE position.
Note: Choke position is defined by moving
the choke lever as far to the Choke position
as possible.
4. Push rocker switch to the ON position.
5. Squeeze throttle control with right hand. Grasp
starter handle with left hand and pull out slowly,
until it pulls slightly harder. Without letting starter
handle retract, pull rope with a rapid full arm
stroke. Let it return to its original position very
slowly until unit fires or runs. Repeat this step
every time the starter rope is pulled.
Note: if engine fails to start after 5-6 pulls,
push primer 1 time and pull starter rope again.
6. After engine starts running, move choke lever to
HALF CHOKE position until unit runs smoothly.
Note: Half choke is defined when the
choke lever is between CHOKE and RUN.
7. Move choke lever to RUN position and move throttle
to desired speed.
NOTE: Run at full throttle when possible. Do not
let unit idle for extended periods of time.
8. To stop engine, push rocker switch to OFF position.
WARM ENGINE START:
1. Move choke lever to CHOKE position.
Note: Choke position is defined by moving
the choke lever as far to the CHOKE position
as possible.
2. Continue with Step 4 of Cold Engine Starting.
HOT ENGINE START:
1. Continue with Step 4 of Cold Engine Starting.
2. If engine does not fire, refer to Step 1 of Warm
Engine Starting.
Adjusting Wheels and Drag Stake
The wheels on the cultivator can be adjusted to one
of three positions. The lowest wheel position is used
for transporting the cultivator across a smooth level
surface while the engine is not running. The two
higher positions are used when cultivating in soil
and help stabilize the unit when cultivating at
different depths.
To adjust wheels up or down:
1. Pull the locking metal sleeve against the spring
until it releases from one of the three holes in
the vertical guide.
2. Slide the wheel set up or down to the desired
position, and release the locking metal sleeve
until it locks into one of the three holes in the
vertical guide.
The drag stake is used to help regulate cultivating
depth and control the cultivator from leaping
forward during operation. Resistance to forward
motion is greatest when the drag stake is set in its
lowest position allowing for deeper cultivation.
To adjust the drag stake:
1. Pull the pin out of the drag stake mount hole.
2. Position the drag stake so the pointed tip is
directed downward.
3. Insert the pin into the hole that achieves
desired depth.