Buell XB 2010, Руководство по обслуживанию

Страница: 111 / 714

2.6 REAR WHEEL
REMOVAL
1. Place a scissor jack under jacking point and raise rear
wheel off ground. For location of jacking point see
4.19 EXHAUST SYSTEM .
NOTE
Do not operate rear brake pedal with rear wheel removed or
caliper piston may be forced out. Reseating piston requires
caliper disassembly.
2. See Figure 2-19 . Remove caliper carrier from swingarm
by removing caliper carrier fasteners. See 2.14 REAR
BRAKE CALIPER .
3. See Figure 2-41 . Loosen rear axle pinch fastener (2).
4. Loosen rear axle (1) approximately 15 rotations to allow
partial tension to be removed from rear drive system.
5. Remove idler pulley assembly. See 5.7 DRIVE BELT AND
IDLER PULLEY, Idler Pulley Removal .
6. Remove lower belt guard. See 2.37 BELT GUARDS .
7. On XB12Ss, XB12XT and XB12X models, it will be
necessary to remove the rear fender. See
2.15 FENDERS .
8. Remove rear axle.
NOTE
Avoid over bending, twisting, crimping, pinching,kinking, or
prying on the drive belt. See
5.7 DRIVE BELT AND IDLER
PULLEY . for proper handling of drive belt.
9. Slide drive belt out of the way and remove rear wheel.
sm00524
Figure 2-19. Rear Brake Caliper Carrier Fasteners
CLEANING AND INSPECTION
Using compressed air to "spin dry" bearings can cause
bearing to fly apart, which could result in death or serious
injury. (00505b)
1. Inspect all parts for damage or excessive wear.
2. Inspect brake rotor. See 1.14 BRAKE SYSTEM MAINTEN-
ANCE and 2.14 REAR BRAKE CALIPER .
REPAIR
Inspection
Using compressed air to "spin dry" bearings can cause
bearing to fly apart, which could result in death or serious
injury. (00505b)
1. Inspect all parts for damage or excessive wear.
2. Measure rotor thickness. Refer to Table 2-19 .
3. Measure radial and lateral rotor runout. Refer to
Table 2-20 .
4. Replace rotor as required.
Table 2-19. Brake Rotor Thickness
in mm DIMENSION
0.18 4.5 Rotor thickness
Table 2-20. Rear Rotor Runout
in mm RUNOUT
0.0177 0.450 Radial
0.0154 0.390 Lateral
Drive Sprocket
Do not re-use sprocket mounting screws. Re-using
sprocket mounting screws can result in torque loss and
damage to the sprocket and/or belt assembly. (00480b)
1. See Figure 2-20 . To remove drive sprocket (3), remove
sprocket fasteners (1) and washers (2). Discard the
fasteners.
2. With the lip of the sprocket facing the inside, position the
sprocket on the wheel.
3. Install new fasteners and washers and tighten to 35-37
ft-lbs (48-50 Nm).
HOME
2010 XB Service: Chassis 2-31