Buell 2006LIGHTNING MODELS, Руководство по обслуживанию, Страница: 104 / 638

1-36 2006 Buell Lightning: Maintenance
HOME
Setting Rear Shock Preload
The factory setting is ramp number 2 position (ramp number 7
position being the tallest ramp and maximum preload). For
recommended spring preload refer to
Table 1-10. or Table 1-
11.
1. Remove seat. See 2.43 SEAT .
2. See Figure 1-32. Change the spring preload by turning
the preload adjuster at the upper part of the shock with
the SHOCK SPANNER WRENCH (HD-94700-52C) or
the wrench included in the tool kit.
a. Turn adjuster to setting specified in Table 1-10. ,
Table 1-11. or Table 1-13. Rotate adjuster clockwise
to increase preload.
b. Rotate adjuster counterclockwise to decrease pre-
load.
1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
3. Install seat. See 2.43 SEAT .
Setting Rear Shock Rebound Damping
1. See Figure 1-33. Using a screwdriver, turn the slotted dial
clockwise until it stops. This is the maximum rebound
damping setting.
2. Then turn the dial counterclockwise the recommended
amount specified in
Table 1-10. , Table 1-11. or Table 1-
13.
Figure 1-32. Rear Shock Preload Adjuster
Figure 1-33. Rear Shock Rebound Adjustment
8388
Maximum preload adjustment (ramp number 7)
Minimum preload adjustment (ramp number 1)
b0954x1x
8416