Budget Robotics - TankBot Servo
Page 4
Copyright (c) 2002-2006, Budget Robotics
Step 2
Using 4-40 x 1/2" machine
screws, nuts, and #4 washers,
secure the servo to the top
mounting slot of the left rail.
The nuts face to the
outside
of
the rail.
Be sure to place the washers as
shown in the inset figure. One
washer should be flush against
the nut, the other flush against
the head of the screw.
Repeat for the bottom of the
servo. Observe the fasteners are
attached at opposite corners of
the servo.
Note: Four sets of fasteners are
provided for each servo, but only
two are needed. Hand-tighten
only at this point.
