Bucktool BG2600, Инструкция по эксплуатации

Страница: 11 / 24

11
1. Mount the work table support (1) to left side of
belt housing (2) using flat washer (3) and hex
cap screw (4).
2. Belt work talbe knob (5) and flat washer (6)
through hole in the work table (7).
3. Thread knob into the work table support (1).
Tighten finger tight.
4. Position work table so that distance between
work table and belt is 1/16˝ or less. Use square
to set work table 90º to belt. Secure all nuts
and bolts tight.
1. Mount work table (1) to left side of belt
housing (2) using hex cap screw (3) and
flat washer (4).
2. Set the work table at right angle to the belt
3. Be sure gap between table and belt is 1/16˝
or less. Tighten hex cap screw (3) to secure
table position.
INSTALLING KNIFE SANDING WORK TABLE
INSTALLING WOOD SANDING WORK TABLE
MOUNTING BELT / DISC SANDER TO WORKBENCH
1. Place the sander on a surface that is level but also provides enough room
on all sides for the workpiece and for the operator (or bystanders) to not be
standing in line with the wood while using the tool. Allow room for the belt to be
positioned horizontally or vertically.
2. The hardware to mount this sander is NOT supplied with the sander.
BG2600
OPERA
TING INSTR
UCTIONS
Attach the belt dust port (1) to the sanding belt
with the philips screws (2). The opening of the
dust port is 1-7/32 inch in diameter and can be
connected to a utility vacuum or a dust collector.
INSTALLING BELT DUST PORT
1
3
2
2
4
5
2
1
6
1
3
4
7