Bucktool BG2600, Инструкция по эксплуатации

Страница: 13 / 24

13
CLEANING
1. Keep machine and workshop clean. Do not allow sawdust to accumulate on the belt.
2. Keep the wheels clean. Dirt on wheels will cause poor tracking and belt slippage.
3. Operate sander with dust collector to keep dust from accumulating.
4. Be certain motor is kept clean and is frequently vacuumed free of dust.
5. Use soap and water to clean painted parts, rubber parts and plastic guards.
BG2600
OPERA
TING INSTR
UCTIONS
BELT VERTICAL SANDING
Your bench grinder sander - belt station can sand vertically as well as horizontally.
Depending on operator needs and the workpiece, the work table can be used
with either the horizontal or vertical position.
To change from one position to the other:
1. Loosen the inner hex screw (1) by turning
it counterclockwise with the 8 mm hex key.
2. Manually move the work support station
into the vertical or horizontal position, as
required.
3. Retighten the inner hex screw (1) by
turning it clockwise.
CONTOUR SANDING
1. Belt platen (1) can be removed for contour
sanding. Loosen locking knob (2) holding
platen to belt housing (3). Control the belt
platen down or remove to use.
2. Replace belt cover and belt cover knobs.
When contour sanding is complete,
replace belt platen. Position belt platen
as close to belt as possible so that platen
does not contact belt.
1
1
3
NOTE: The maximum down distance of the belt platen is 2.5cm.
NOTE: After sanding wood or non-metallic material, always clean dust collector and
guards of sawdust before grinding metal. Sparks could ignite debris and cause a fire.
2