Buckeye RC-5000, Руководство пользователя

Страница: 20 / 40

19
Portable Base Section
Questions? Contact us at buckeyecam@buckeyecam.com or call (866) 325-8172
19
Questions? Contact us at buckeyecam@buckeyecam.com or call (866) 325-8172
• Make sure the camera powers up and the display
shows “
REG CAM ” with a scrolling bar in the upper left
hand corner. If REG CAM does not appear, the Camera
is either registered to a Base or is in Stand-Alone Mode.
• Make sure the camera and base both have antennas
connected and the batteries are charged 50% or more.
2. Press the “ Menu ” button on your portable base.
3. Using the “Up and Down” buttons located to the right
of the display on your base, scroll until you see
“
AddCam ” on the display.
4. Once you see “ AddCam ” on your display press the
“ Select ” button on your base (second button on the
right side between save pics to card and set clock).
5. The camera will be automatically added and the
display will show the status of the camera being
added.
6. Once your camera has been added you will see “ Turn
power off ” on the display of the camera. Turn off the
power to the camera. At this point the camera has
been added to your base and is ready to be used.
7. After your camera has been added press the “ Select ”
button on your portable base to go back to the Main
Menu.
8. Repeat these steps to add more cameras (up to 14
cameras total).
B. Deleting a Camera from a Portable Base
Do not turn off the camera or base until the following
process is complete.
1. Make sure the portable base is near the camera you
want to delete.
2. Make sure your camera is on and the battery level is
50% charged or more
3. Test the communication between the camera and the
base by pressing the “
Signal ” button on your base.