btsr SMART KTF 2000, Руководство по эксплуатации

Страница: 87 / 145

SMART KTF 2000 – KTF/RW Operation
SMART KTF 2000 3B-19 -
SENSOR TEST - KTF/RW Device Test
SETUP CONFIG TEST SENSOR
This function gives you the possibility to check the dialogue between the SMART
KTF 2000 terminal and (one by one) each of the connected KTF/RW devices.
In this way it is possible to check that:
All devices are correctly numbered and identified
All devices respond correctly to the terminal
The same number has not been assigned to more than 1 device.
This function is particularly useful during the testing phase (immediately after
installation) and when operation problems occur, which require a test of each
individual device.
The test does not show diagnostic messages on the SMART KTF 2000 display!
The operator shall simply select the number of the desired device (DEV XXX) using
the NEXT CY button and confirm that the
COM
led of the selected KTF/RW are
flashing.
Once you have selected the > TEST CONFIG screen, press to access the
function.
This screen indicates that the device test is going to start.
Press to continue.
DEV XXX indicates the device which is being tested
(initially device no. 1). Check
that the
COM
led on device XXX are flashing and that there are no other device
with such led flashing.
If the
COM
led on KTF/RW device that should respond to the number XXX
are not flashing, it means that the device is faulty or that the device numbering
procedure has not been performed correctly. In this case try to renumber the
devices (see: DEVICE - “Numbering the KTF/RW Devices”) and, if required,
replace the device.
If the
COM
led are flashing on more than one device, it means that the same
number has been assigned to multiple devices. In this case it will be necessary
to repeat the device numbering procedure (see: DEVICE - “Numbering the
KTF/RW Devices”).
Press to select the next KTF device and check that the
COM
led on that
selected device are flashing.
Repeat this test for all connected KTF devices.
Press once to leave this function and return to the >TEST screen, or press it
several times to return to the Main Menu.