btsr SMART KTF 2000, Руководство по эксплуатации

Страница: 31 / 145

SMART KTF 2000 – KTF/100HP Operation
SMART KTF 2000 3A-11 -
2) Machine hardware setting
in Stop at End of Cycle mode
- PRX – Proximity not necessary
- ZPX – Start/End Cycle Signal
- RESET EXT – Reset of alarm condition without
operating on terminal
System software settings
Menu CONTROL TOLL : Set the Control Tolerances
Operating Procedures in case of Immediate Stop mode
4) – From CONTROL environment perform the “LEARN” function – Length of
Absorbed Yarn (LFA).
5) – At the end of the Learn phase the system switches to CONTROL mode and,
upon the PRX pulse it will compare the previously “Learnt” value with the
“currently detected” value.
1) – If the difference between the “Learnt” LFA value and the “detected” LFA
value exceeds the tolerance, the machine will be stopped.
Application
Machine hardware setting
- PRX – Proximity detecting the number of revolutions.
You will have to install a number of magnets (PRX)
equivalent to the number of controls/revolution
you want to carry out
- ZPX – Not necessary
- RESET EXT – Reset of alarm condition without
operating on terminal
System software settings
Menu SETUP SYSTEM : Set FEED = Number of machine drops
Set PRX/R = Number of installed Magnets
(PRX)
C-KNIT
Cycle Start
Reset Counters
Cycle End
Counter reading and comparison
between Learnt Value and Detected Value
Signal Requested
Counter reading and comparison
between Learnt Value and Detected
Value
Signal Requested