2/15
ELIOT Kit Salvavita Connesso
Cat. N°: G723SC
1. DESCRIPTION - USE
With a Smartphone, to remotely switch ON/OFF a circuit protected
by a 1 module per pole BTDIN RCCB or RCBO up to 63 A.
(not
delivered with the kit).
Must be used with the app “POWER ON”
available on Google Play and Play Store.
In case of unwanted tripping (temporarily electrical disturbances or
other external events) and if no permanent fault is detected: it will
send a message to the user in order to get an authorization to switch
ON the associated device.
In case of permanent fault: the user will be informed about it without
having the possibility to remotely switch on the power.
2. RANGE
. Cat. n° G723SC: Eliot Kit “Salvavita Connesso”, composed by:
Non-automatic resetting Salvavita Connesso (cat. no G723SC)
. During a “normal situation”:
- It permanently checks the status of the installation.
- It allows the user to remotely switch ON/OFF the associated
device
. During an “unwanted tripping” due to a non permanent fault:
- It reports the information through the Smartphone app
- Allows the user to remotely switch it ON
- In case of recurrent non permanent faults, the Salvavita
Connesso will not allow some remote command
(see details on page
5)
. During an “unwanted tripping” due to a permanent fault (earth
leakage or short circuit):
- It reports the information through the Smartphone app
- It does not allow the use to remotely switch On the device and
advises to contact an electrician to check the installation.
. Technology: DC electric motor with permanent magnets
. 2 modules (35,6 mm) width
. Rated Voltage & Frequency: 230 V ~ 50 / 60 Hz with standard
tolerances.
. Operating voltages:
Minimum (0,85 x Un): 195,5 V
Maximum (1,1 x Un): 253 V
Wi-Fi interface module (cat. no F80IIP)
To communicate with the Smartphone through a Wi-Fi Box
. 1 module (17,8 mm) width
. Supplied by the Power supply module via supply patch cord
. Equipped with a 1m length pre-cabled cable to connect with the
Salvavita Connesso
Supply patch cord:
. Allows to connect the Power supply module with the Wi-Fi interface
at the downstream through dedicated connectors.
. Length: 250 mm
2. RANGE
(continued)
Configuration & use:
. Must be used with the app “POWER ON”
. To be downloaded for free on Google Play or App Store
All the configurations steps are explained in the app.
Note: This part can be done without any ADSL Wi-Fi box thanks to the
Wi-Fi module which allows to display its own network for this step.
3. OVERALL DIMENSIONS
. Salvavita Connesso
. Wi-Fi interface module (already equipped with an external Half Wave
2.4GHz Antenna With RP-SMA Connector):
Technical data sheet: IDP000172EN_01
Updated: -
Created: 08/09/2017
