2 Pin Analog Out Connector (Brown and Blue Wires)
The two pin DTM connector is used for an analog output for bo
option is not used when using the CAN XMIT option.
programmed using the BOOST PWM STEPS and TRAC PWM STEPS buttons in the settings.
Idealy, more features may be controlled by using the CAN bus output instead of the analog
outputs. Connect the blue and brown wires to the corresponding inputs that are selected for
your application. There are more details regarding
Notice: The gender of the 2 pin plug may be reversed on newer models in order to prevent the improper
connection to the “Flash Enable” connector.
Data LED: This indicator will flash when ever the gauge is energized and CAN communications
are present. Use this to confirm communications.
CAN Bus Termination Jumper: Remove this jumper if the gauge is not the last device on the
CAN Bus. If there are multiple gauges, the last gauge should be the only gauge with the jumper
installed.
2 Pin Analog Out Connector (Brown and Blue Wires)
The two pin DTM connector is used for an analog output for boost and traction control.
option is not used when using the CAN XMIT option.
The number of voltage steps may be
programmed using the BOOST PWM STEPS and TRAC PWM STEPS buttons in the settings.
, more features may be controlled by using the CAN bus output instead of the analog
Connect the blue and brown wires to the corresponding inputs that are selected for
e details regarding under the Gauge Setup Optio
Notice: The gender of the 2 pin plug may be reversed on newer models in order to prevent the improper
connection to the “Flash Enable” connector.
Data LED: This indicator will flash when ever the gauge is energized and CAN communications
are present. Use this to confirm communications.
CAN Bus Termination Jumper: Remove this jumper if the gauge is not the last device on the
CAN Bus. If there are multiple gauges, the last gauge should be the only gauge with the jumper
2 Pin Analog Out Connector (Brown and Blue Wires)
ost and traction control.
This
The number of voltage steps may be
programmed using the BOOST PWM STEPS and TRAC PWM STEPS buttons in the settings.
, more features may be controlled by using the CAN bus output instead of the analog
Connect the blue and brown wires to the corresponding inputs that are selected for
under the Gauge Setup Options section.
Notice: The gender of the 2 pin plug may be reversed on newer models in order to prevent the improper
Data LED: This indicator will flash when ever the gauge is energized and CAN communications
CAN Bus Termination Jumper: Remove this jumper if the gauge is not the last device on the
CAN Bus. If there are multiple gauges, the last gauge should be the only gauge with the jumper
