ground.
** When using the CAN XMIT, Boost PWM steps and TRAC PWM steps will determine the
number of steps that are sent over the CAN bus.
** Note that these two settings should be configured by competent
personnel. Raising the BOOST too much or reducing the SLIP too much can
have severe consequences. **
Example CAN transmit configuration in M1 Tune
In order to transmit CAN commands over the CAN bus to the M1 ECU, the ADR CAN bus must
be configured The ADR CAN ID is entered in the M1 Tune software as a decimal value.
The same value must be entered into the BTI touch screen as a decimal value as well:
**Note that CAN XMIT must be enabled in the setup screen.
Press the white cog wheel in order to enter the CAN control screen:
Press the yellow cog wheel in order to configure the
ADR CAN ID
Once the ADR CAN ID is configured, the inputs for the control buttons must be configured in the
M1 Tune software
