Mobile1 Path and if registered
with the platform.
Mobile1 operator. This will
always be EE.
The unit may also show Low
Battery if the supply voltage is
below the supply threshold.
The performance category can only be determined by the unit while in contact with
the platform. The unit will not show the performance category until at least one path
is registered and the profile can be retrieved from the platform.
Signal strength – network type
(4G or 2G) received wireless
signal strength in dBm and signal
strength indicator bars. Two bars
or more is the recommended
signal level required.
Mobile2 Operator. This could be
any of the main UK networks.
Mobile2 Path and if registered
with the platform.
Unit initialisation
The unit will immediately attempt to connect to the BT Redcare platform over the
configured paths. The unit will typically complete path establishment in the following
times from power up.
Status display
The unit clearly displays its status on the OLED. In its normal working state,
the unit will cycle its display.
Mobile 1
120s
Mobile 2
180s
Path: Mobile1
Registered
Path: Mobile2
Registered
Mobile1 Strength
4G [ ] [-103]
Mobile2 Strength
4G [ ] [-101]
Mobile2 Operator
Three
Alarms Battery
Low Battery
Mobile1 Operator
EE
Alarms GPI Alarm
3
Service Grade
Redcare DP2 R
Figure 4 – time to commission paths after unit power up
Programming
Service Grade – shows the EN
Performance category.
Pin status – any outstanding alarm
pins will be shown. If no pins are in
the alarm state, then pin status will
not be shown.
9