2
Description
8/108
CLS Pro 600 – Line and Contrast Sensor
2
Description
2.1
General Information
WARNING
Please note:
The start-up, maintenance and installation instructions described
in this operating manual must be strictly adhered to!
You are only permitted to install and commission the
CLS Pro
600
line and contrast sensor after you have read the accompany-
ing operating manual. This will help to avoid hazards and prevent
the sensors from being damage due to improper installation or
operation.
Everyone working on or with the
CLS Pro 600
sensor must abide by
this operating manual and the safety instructions in particular.
You must read, without fail, the safety instructions given in
Chapter 2.6 of this operating manual prior to starting the installa-
tion and commissioning work!
Solely BST-eltromat staff or other persons specifically authorized
by BST-eltromat are permitted to modify or add to the firmware
of this sensor. Ignoring this warning might result in the warranty
rights being invalidated.
The settings and details shown in this operating manual (e.g. in
the display screens) are given as examples only, unless the text ex-
plicitly states otherwise.
The latest version of the operating manual for the
CLS Pro 600
line
and contrast sensor can be obtained via the Internet in all avail-
able languages under the following address:
http://www.bst-eltromat.com
2.2
Intended Use
The
CLS Pro 600
is a microprocessor controlled line and contrast
sensor with a removable control panel. It must only be used for:
■
Guiding on continuous or interrupted printed lines
■
Guiding over continuous or interrupted printed edges
■
Web edges
The
CLS Pro 600
line and contrast sensor has been designed to be
fitted in another machine or to be combined with other machines
to form a complete machine in the sense of the Directive
2006/42/EC (machine directive). Start-up of the system is forbid-
den until the user / operator has determined that the machine, in
which the system is installed, conforms to the conditions of this
directive.