PWA-220
WWW.BSTDJ.COM
© Copyright LOTRONIC 2014
Page 14
4)
CONTROL PANEL DESCRIPTION
1. FUSE
The fuse protects the speaker against surges. If the enclosure does not light, check the fuse. If that is burnt or broken, replace it by one of
the same size and value.
2. EXTERNAL
SPEAKER
OUTPUT
This output allows you to connect a passive additional speaker
3. PWA BROADCAST VOLUME CONTROL / ON-OFF BUTTON
Press this button to turn on or turn off the PWA broadcast module. It is also used to adjust the volume of this module
.
4. TX / RX SELECTOR
This selector allows to choose the operating mode of the PWA BROADCAST module. Transmitter (TX) and receiver (RX)
If you want to use the speaker in master (that is, the signal of this enclosure will be sent to an other PWA220), turn the switch on TX. On
the other hand, if you want to use this speaker as slave (that is, you will receive the audio signal coming from a master PWA220, set the
selector on RX
5. LINK INPUT LEVEL CONTROL BUTTON
This setting allows to adjust the level of the signal input link. This setting is active only when the speaker is positioned in slave mode
(button 6)
