PWA-220
WWW.BSTDJ.COM
© Copyright LOTRONIC 2014
Page 17
5. BLUETOOTH LED
When the green led is lit, this indicates that the bluetooth module is turned on. if immediately, it begins flashing green/orange, this means
that it is in searching bluetooth device mode and no device is connected. ;
Once you have selected the module on your audio source (tablet, smatrphone, computer,...), the led must light green what indicator means
that the module is connected. during playback, the led flashes slowly in green and then orange.
The bluetooth source sought on your audio source is: M_BLUE_AUDIO
7)
HANDHELD WIRELESS MIC DESCRIPTION
8)
BELT TRANSMITTER DESCRIPTION
1. CARTRIDGE
2. ON / OFF LED
When you turn on the microphone, the light should flash once. If the indicator lights on,
this means that the batteries are too low. You must to change for new ones
3. POWER SWITCH
Use to switch the handheld mic on or off
4. GAIN
CONTROL
Adjusts the level of the wireless microphone
5. BATTERIES PLACE
Insert two 1.5V batteries ( pay attention to the polarity). The operating time is about
8 hours
1. ANTENNA
2. ON / OFF LED
When you turn on the microphone, the light should flash once. If the indicator lights on,
that means that the batteries are too low. You must to replace its
3. MIC INPUT
Connect your headset to this input. Note: screw jack socket. It is necessary to hold the
jack connector and then screw it
4. SENSITIVITY MIC CONTROL
Allows to adjust the input sensitivity following mic that you connect
5. ON – STB – OFF BUTTON
Three positions :
- Off : Belt transmitter off
- Standby : Belt transmitter on but no sound is sended to speaker
- On : Belt transmitter on and sound is sended to speaker