PWA-220
WWW.BSTDJ.COM
© Copyright LOTRONIC 2014
Page 16
5)
WIRELESS RECEIVER DESCRIPTION
1. RF LED
This led will lights on when the corresponding wireless microphone is switched on. That means the connection between the wireless
microphone and the receiver signal is correct. if this led doesn’t light:
- make sure the microphone is turned on
- check the batteries in the microphone
- check that the receiver is switched on (button 4)
2. VUMETER
these leds give you a visual indication on the level of the signal from the wireless microphone
-
if only the green led (-30, -20 and -10) lights, it means that the signal is good
-
if the leds orange (0) begins to flash, this means that the level is good but is close to saturation
-
if all leds light up, this means that the level from the microphone is too strong. the sound may be saturated (bad). it is necessary
to reduce the level of the microphone using the volume control located on the microphone (if available) or to speak more away
from the microphone
3.
SQUELSH CONTROL
The squelch control is preset at the factory. If you have a lot of interference, adjust the potentiometer mute so as to eliminate interference
4. VOLUME CONTROL / ON-OFF BUTTON
This knob will adjust the wireless receiver output level. it allows also to turn on or turn off the wireless receiver
6)
BLUETOOTH MODULE DESCRIPTION
1. VOLUME CONTROL / ON-OFF BUTTON
This knob will adjust the bluetooth receiver output level. it allows also to turn on or turn off the bluetooth receiver
2. SELECTION BUTTON
Allows you to come to the beginning of the song or to select the previous song
3. PLAY/PAUSE BUTTON
Used to play or pause song
4. SELECTION BUTTON
Allows you to select the next song
