BSS Audio TCS 80X, Руководство пользователя

Страница: 21 / 46

21
To Adjust Output
Levels
At any time when in the LEVEL mode, a delay button can be selected to
allow trimming of output gain. The adjacent LED will stop flashing and
remain on, to indicate selection. The display will change to show the input to
output through gain, in dB, for the output selected.
Turn the knob to set the gain required in dB
One of the many advantages of this digital level control is seen when
adjusting input headroom. The input to output through gain will always be
held constant at the dB value previously set because internal circuitry
automatically provides the necessary correction to output level. This will be
limited to a range such that the sum of input headroom in dB plus the through
gain in dB is within a range greater than -10dB and less than +20dB and
ensures that the output circuitry can not be set to clip the signal.
WHEN INITIALLY SETTING UP THE UNIT, BE SURE TO SET ALL OUTPUT
GAINS TO 0dB. PROCEED TO SET INPUT HEADROOM, AND FINALLY
TRIM EACH OUTPUT GAIN TO SUIT. FAILURE TO FOLLOW THIS ROUTINE
MIGHT CAUSE THE AUTOMATIC THROUGH GAIN COMPENSATING
CIRCUITRY TO RUN OUT OF RANGE.
11.5 Output
Mutes
The
TCS-804
will also allow independent muting each of the four delay
outputs.
Enter the ‘LEVEL’ mode:
Press in control knob.
Press and turn.
And select the delay output to mute.