BSS Audio
DPR-402 User Manual v3.0
Page 11
9
.2 Outputs
The output connection is a standard 3 pin male XLR. Output impedance is less
than 1 ohm, unbalanced, and full headroom is available into any load 600 ohms
or greater. The signal 'hot' is connected to pin 3, and the ground to pin 2 and pin
1.
For rack mounted unbalanced audio systems, the case (power) ground can be
isolated from the signal by removing an internal wire link associated with channel
one output.
9
.3 Stereo Link
This facility enables the two channels of the
DPR-402
to be used in a stereo
system, with the result that there is no image shifting under comparison on either
channel. This switch actually couples the detector outputs from both channels
together, so that either one responds to the largest signal present. When in stereo
mode, the front panel 'LINK' LED will illuminate, and care should be taken to
ensure that both channels have their controls set equally. For other methods of
multiple channel coupling,
refer to section 14; Operation and Applications.
9
.4 Barrier Strip
This interface facility provides various input and output signals to the unit,
allowing other dynamic controlling features to be realised. This strip also includes
the two insertion points for external equipment connections, and in the absence of
these, the two indicated shorting links must be made to allow normal operation of
the unit.
Please refer to section 14; Operation and Applications for examples of
possible uses.
9
.5 Peak Limiter Switch
This fast/slow selector changes the dynamic response of the peak limiter section to
best suit the particular program material.
Please refer to section 12.4; Peak
Limiting for applications and usage.
