Form: 2435
Revision: 9
Free Flex Installation and Operation Manual
Date: 9-1-2017
Bryan Steam LLC, 783 N Chili Ave, Peru IN 46970
Web:
www.
bryanboilers
.com
Phone:
765-473-6651
Fax:
765-473-3074
Email:
37
5
Service, Maintenance, and Inspection
5.1
General Maintenance:
1.
Follow any checks and/or inspections that
may be required as specified in the
component manufacturers’ instruction
manuals.
2.
Repair or replace any defective
components immediately.
3.
The following service procedures are
required for proper and safe boiler
operation.
DANGER
This boiler uses flammable gas, high
voltage electricity, moving parts, and very
hot water under high pressure. Assure that
all gas and electric power supplies are off
and that the water temperature is cool
before attempting any disassembly or
service.
More than one gas shut-off valve and
electrical disconnect switch are used on
the boiler. Assure that all gas valves and
electrical disconnect switches are off
before attempting any disassembly or
service.
Do not attempt any service work if gas is
present in the air in the vicinity of the
boiler. Never modify, removed or tamper
with any control device.
Do not use matches, candles, open flames
or other ignition source to check for leaks.
WARNING
This boiler must be serviced and repaired
by skilled and experienced service
technicians only.
If any controls are replaced, they must be
replaced with identical models supplied
by Bryan Steam.
Read, understand and follow all the
instructions and warnings contained in all
the sections of this manual. The
instructions and warnings contained in all
of the component instruction manuals.
If any electrical wires are disconnected
during service, clearly label the wire and
ensure that the wires are reconnected
properly.
Never jump out or bypass any safety or
operating control or components of this
boiler.
Assure that all safety and operating
controls and components are operating
properly before placing boiler back in
service.
WARNING
The service instructions contained in this
manual are in addition to the instructions
provided by the manufacturer of the boiler
components. Follow component
manufacturer’s instructions. Component
manufacturer’s instructions were provided
with the boiler. Contact component
manufacturer or Bryan Steam for
replacement if instructions are missing.
Do not install, start up, operate, maintain
or service this boiler without reading and
understanding all of the component
instructions. Do not allow the boiler to
operate with altered, disconnected or
jumpered components. Only use
replacement components identical to
those originally supplied by Bryan Steam.
All cover plates, enclosures, and guards
must be in place at all times, except
during maintenance and servicing.
5.1.1
DAILY:
1.
Make visual inspection of gauges,
monitors, and indicators and record
readings in boiler log.