© Brüel & Kjær Vibro
● C107758.002 / V04
Page 17 of 42
Technical alterations reserved!
Brüel & Kjær Vibro
│
Installation instruction VCM-3 / VCM-3 Ex
Basic operation of the VCM-3
EN
UNRESTRICTED DOCUMENT
5.4
Reset to default IP address
In the case that the IP address is unknown it is possible to access the VCM-3 using the factory default
IP address. Please follow the procedure below.
How to reset the IP Address of VCM-3 to its default (temporarily)
Step
Explanation
1
Push the logo for approximately 10 seconds until the Online status LED turns into dark blue.
(When you push the logo, you shall feel a tactile feedback)
When the Online status turns into dark blue the VCM-3 allows a user to login using the default IP
address:
https://192.168.2.202
.
The VCM-3 will remain in this state until a new IP address has been saved or the VCM-3 is rebooted.
Change the laptop network settings to match the IP range of the VCM-3.
E.g. Set the laptop to IPv4 address 192.168.2.199, Netmask 255.255.255.0
NOTE!
Refer to
C107762.002 EN VCM-3 Homepage Manual
for a description of the
procedure of how to change the network settings of the laptop.
2
Log into the VCM-3. Refer to the description in
C107762.002 EN VCM-3 Homepage Manual
3
Select the
“Commissioning Configuration” page. On this page the IP setting of VCM-3 is displayed.
Change it if required. Remember to click
Save Changes
