BRP Ski-doo Tundra Series, Руководство оператора

Страница: 73 / 171

BASIC PROCEDURES
WARNING
Make sure tether cord cap and key
are removed before standing in
front the vehicle, getting close to
the track or rear suspension com-
ponents.
NOTE: On E-TEC models, warm-up is
controlled by the engine management
system. During this period (up to 10
minutes depending on ambient tem-
perature), engine RPM is limited.
Shifting in Reverse or
Forward
WARNING
When shifting in reverse, wait un-
til the reverse alarm sounds and
the pilot lamp comes on in the
analog/digital gauge before oper-
ating throttle. The reverse speed is
not limited. Always proceed with
caution as fast reverse could result
in loss of vehicle stability. Come
to complete stop before depress-
ing engaging the reverse. Always
remain seated and apply the brake
before shifting. Ensure the path
behind is clear of obstacles or by-
standers before proceeding.
Reverse (Manual Shift)
Shifting in Reverse
To engage reverse gear, proceed as fol-
lows:
1. Bring vehicle to a complete stop.
2. Apply and hold brake. Remain
seated, refer to
RIDER POSITION
(REVERSE OPERATION)
for pos-
ture information.
3. With engine at idle speed, pull the
reverse shift lever all the way out.
4. Gently depress throttle lever.
Shifting in Forward
To engage forward gear, proceed as
follows:
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. With engine at idle speed, push the
reverse shift lever all the way in.
4. Gently depress throttle lever.
Reverse (RER)
When the engine is running, depress-
ing the RER button will slow down en-
gine RPM to almost a stop and advance
the ignition timing to invert crankshaft
rotation.
– Engine will automatically shift into
forward when restarting after stop-
ping or stalling.
– Shifting procedure will take place
only when the engine is running.
– If engine is running at a speed above
4300 RPM, the function of the RER
button is disabled.
– It is recommended to warm up the
engine to its normal operating tem-
perature before shifting.
Shifting in Reverse
1. Bring vehicle to a complete stop.
2. Apply and hold brake. Remain
seated, refer to
RIDER POSITION
(REVERSE OPERATION)
for pos-
ture information.
3. With engine at idle speed, press and
release the RER button.
4. Wait until reverse beeper sounds,
then gently depress throttle lever.
Shifting in Forward
1. Bring vehicle to a complete stop.
2. Apply and hold brake.
3. Press and release the RER button.
4. RER pilot lamp will stop.
5. Apply throttle slowly and evenly. Al-
low drive pulley to engage then ac-
celerate carefully.
_______________
71