BRP Sea-Doo MOVE I 1250 Long Galvanized/Painted Black, Руководство оператора

Страница: 23 / 68

23
T TY YP PIIC CA AL L
1. Winch support retaining nuts
2. Mounting plate
T Tiig gh htte en niin ng g tto orrq qu ue e
Winch support
retaining nuts
34 Nm (25 lbf-ft)
To adjust front to rear winch position,
loosen the six (6) nuts, move forward
or rearward to desired position, then
tighten nuts as per the following table.
T TY YP PIIC CA AL L
1. Winch support retaining nuts
T Tiig gh htte en niin ng g tto orrq qu ue e
Winch support
retaining nuts
34 Nm (25 lbf-ft)
B Bo ow w S Stto op pp pe err R Ro olllle err
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet (or bow cup
on selected models).
1. Area where the roller must lean
To adjust:
1. Loosen the four (4) winch adjust-
ment nuts as shown.
2. Set the bow roller stopper to the
desired height, then lock it in posi-
tion by tightening nuts as per the
following table.
T TY YP PIIC CA AL L
1. Winch adjustment nuts
T Tiig gh htte en niin ng g tto orrq qu ue e
Winch
adjustment
nuts
34 Nm (25
lbf-ft)
B Bu un nkkss
B Bu un nkk A An ng glle e
To adjust the angle:
1. With the PWC off the trailer, loos-
en the bolts retaining the bunk to
its support.
TRAILER SET-UP