BRP Evinrude E-TEC, Руководство пользователя

Страница: 218 / 364

Powerhead
Powerhead Assembly
218
Test at least three corners of the rod and cap joint
with a pick. Joint must be smooth with no step.
Crankcase Assembly
Make sure crankshaft is still seated on dowel pins
before assembling crankcase.
Thoroughly clean and degrease the mating
flanges of the crankcase and cylinder block with a
non-petroleum based solvent, such as isopropyl
alcohol or acetone, and let air dry.
IMPORTANT:
DO NOT allow solvent to get on
internal components. Clean only the mating flang-
es.
Apply Gasket Sealing Compound to lower oil seal
groove in crankcase. DO NOT put any sealer in
upper seal groove.
Use a small brush with a tapping motion to apply a
thin, even coat of
Gel-Seal II sealant to the crank-
case mating flange. The sealer must not come
within 1/4 in. (6.4 mm) of bearings.
IMPORTANT:
Gel-Seal II has a shelf life of at
least one year when stored at room temperature.
Test the
Gel-Seal II or replace it if the age of the
tube cannot be determined. Using old Gel-Seal II
could cause crankcase air leaks.
IMPORTANT:
The use of Locquic Primer is NOT
recommended. If primer is used, crankcase halves
must be assembled and tightened within ten min-
utes after the
Gel-Seal II has been applied.
Lower the crankcase into place. Make sure that
upper oil seal and lower seal housing are seated
in grooves.
Apply outboard lubricant to the main bearing
studs. Install nuts and washers finger tight, no
more than 60 in. lbs. (7 N·m).
When the crankcase is seated, install and firmly
seat the crankcase taper pin.
Tighten main bearing nuts in stages to a final
torque of:
•
26 to 30 ft. lbs. (35 to 41 N·m).
005300
Typical 003874
002271
002260