BRP Evinrude E-TEC, Руководство пользователя

Страница: 63 / 364

63
Engine Management Module (EMM)
External Sensors
4
5 V Circuit Sensor
Monitors the EMM ’s 5 V sensor circuit.
If sensor voltage is less than 4.75 volts, the EMM :
Barometric Pressure Sensor
Supplies the EMM with barometric pressure read-
ing to compensate for changes in altitude and air
density.
If the BP sensor reads less than 13.3 KPa or
greater than 119.0 KPa, or the sensor or circuit
fails, the
EMM:
If the BP sensor reads less than 70 KPa, the
EMM:
If the BP sensor reads greater than 105 KPa, the
EMM:
External Sensors
Sensor inputs and internal EMM controllers are
used to control outboard operation. Use Evinrude
Diagnostics software to troubleshoot the sensors.
Refer to the EMM Service Code Chart at the
back of this manual for a complete list of all
engine fault codes.
The EMM provides a 5 V DC signal for sensor cir-
cuits. It monitors all sensor voltage inputs and
compares them to predetermined acceptable
ranges. Inputs that fall outside of the acceptable
range create service codes.
Air Temperature Sensor
The air temperature sensor monitors the air tem-
perature at the throttle body.
If the AT sensor voltage is out of the expected
range, or the sensor or circuit fails, the
EMM:
Engine Temperature Sensor
Monitors cylinder head temperature.
3-Cylinder Models
If cylinder head temperature exceeds 212° F
(100° C) below 3500 RPM , the EMM :
If cylinder head temperature exceeds 194° F
(90° C) above 3500 RPM , the EMM :
Stores service code 78
EMM LED 3: OFF (Cranking)
EMM LED 3: ON (Running)
Stores service code 44
Stores a service code 45
Stores service code 46
Stores service code 47, 48, or 49
EMM LED 3: OFF (Cranking)
EMM LED 3: ON (Running)
Activates S.A.F.E.
Stores service code 40
EMM LED 4: ON (Running)
Engine Monitor TEMP display: ON
Activates S.A.F.E.
Stores service code 43
EMM LED 4: ON (Running)
Engine Monitor TEMP display: ON