BROWN HTS-3020 3000, Руководство владельца/оператора

Страница: 23 / 40

23
Maintenance
Tightening Carbide Tip Bolts
Inspect carbide tip screws each hour for the first eight hours of use for proper torque.
Repeat hourly
inspections each time the carbide tips are removed/replaced.
1. Disengage hydraulics; be certain that all rotation has stopped.
2. Lift Tree Saw high enough to place suitable supports under the Tree Saw deck.
3. Turn Skid steer engine off; remove key; lock transmission and brakes; chock rear wheels.
4. Disconnect hydraulic lines.
5.
Warning! Failure to keep blade carrier bolts tight can and will cause: blade breakage; warping
of blade bar; and/or ejection of blade from TreeSaw. These hazards can cause serious injury or
death.
Warning! If blade tip bolts are allowed to run loose, the obvious danger is for the bolts to come
out, allowing the blade tips to be ejected from the Tree Saw.
The described occurrences will cause the blade to break and be ejected. An ejected blade
can and will cause serious injury or death.
Proper Bearing Block Lubrication
Connect grease gun, with proper lubricant ( Mobiltemp SHC 32 Grease), onto grease fitting on bearing
block. Pump grease into unit until grease comes out of pressure vent in the opposite side of the bear-
ing block. Do not overgrease. Make certain both fittings are tightened securely before operating.