BROWN Firefly, Руководство пользователя

Страница: 30 / 46

BrownDigital FireFly maintenance guide
Figure 4: Belt Tracking
Check Bulb Status:
1) At each drone control panel press
“Menu”
2) Press “Factory Setup”
3) Press “Test Bulbs”
4) Bulb test will report “Successful” if all
bulbs are working correctly, or will
identify those bulbs that are not
working.
Replacing a Bulb:
Before replacing a bulb, it is important to
determine that the bulb is, in fact, the problem.
1) With nothing on the belt, make sure the
lane with the suspect bulb has been
started (use the “start/stop job” option
on the main kiosk.
2) On the Drone control panel, select
“Menu”.
3) Select “Factory Setup”
4) Select “Bulb Setup”
5) Choose belt (zone) in question (Figure
5)
6) Circles at the right of the image
represent bulbs in the zone. (Front bulb
is the bottom circle.)
7) Press circle corresponding to suspect
bulb. If the circle turns green, the bulb is
being commanded to turn on.
8) Visibly inspect the bulb to see if it is on
or on or not.
If the bulb is truly not coming on, it should be
replaced.
1) Turn off the machine.
2) Turn off all disconnect switches (red
knobs on drone panels)
3) Pull sections apart if necessary to access
the bulb rack with a bad bulb (Figure 6).
Note wire conduit strain while moving
sections.
4) Pull bulb rack out.
5) Remove guards to access bulb wire
connections.
6) Disconnect wires to bulb.
7) Pull wires out of bulb rack metal.
8) Remove bulb from rack by sliding bulb
left and right. (It will probably be
necessary to use fingers to slightly
expand bulb holders to allow bulbs to
slide).
9) Reverse steps to install a new bulb.
Wear gloves when handling a new bulb.
Hand oils can cause bulbs to overheat.
Figure 5: Bulb Control Screen
Figure 6: Bulb Access
3