BW1253s User Guide v1.0
Nov. 2013
Page 136 of 180
Services
Services | Telnet
Use
Services | Telnet
menu to manage the telnet/SSH service of your BW1253s.
Figure 238 – System Configuration settings
Telnet Service
– Enable or disable telnet service of BW1253s
SSH Service
– Enable or disable SSH service of BW1253s
The default of these two services are all
Enabled
. The current IETF SSH (SSHv2) is supported for
security of accessing BW1253s via telnet/CLISH.
Services | SNMP
SNMP
is the standard protocol that regulates network management over the Internet. To
communicate with SNMP manager you must set up the same
SNMP
communities and identifiers on
both ends: manager and agent.
Use the
Services | SNMP
menu to change current SNMP configuration.
Figure 239 – SNMP settings
Readonly community
– community name is used in SNMP version 1 and version 2c. Read-only
(public) community allows reading values, but denies any attempt to change values [1-32 all ASCII
printable characters, no spaces]
Readwrite community
– community name is used in SNMP version 1 and version 2c. Read-write
(private) community allows to read and (where possible) change values [1-32 all ASCII printable
characters, no spaces]
Default Trap community –
the default SNMP community name used for traps without specified
communities. The default community by most systems is "public". The community string must match
the community string used by the SNMP network management system (NMS) [1-32 all ASCII
printable characters, no spaces]
