Brouwer 1570, Руководство оператора

Страница: 49 / 66

Fine Adjust Control.
As noted on page 6-02, the Fine Adjust Control
allows the operator to trim the waste strip. It is
recommended that it is set-up as follows:
Set the Fine Adjust Control to its ‘Mid-Point’ by:

Releasing the Control Lock ‘ A ’.

Press the End Button ‘ B ’, and slide the Control
Knob
‘ IN’ or ‘ OUT ,’ to find the mid-point of travel.

Re-tighten the Control Lock.
Actuator Column.
Spring Tension Adjustment.
CAUTION
The Top Lever Arm is under spring tension.
Exercise care when removing the Cable Clevis End
from
the Top Lever Arm, or loosening the Lever Arm
Clamp Bolt.
Position the Guide Shoe against the cut edge of
turf :

Remove Clevis End ‘ C ’, from Top Lever Arm ‘ D ’.

Loosen the Shoe Arm Clamp Bolt ‘ E ’.
The Top Lever Arm ‘ D ’, should rotate ‘clockwise’
approximately 80 to 90 degrees , releasing the
spring tension.
If the Lever Arm rotates ‘back’
less than 80 degrees,
re-set it by loosening the Clamp Bolt ‘ F ’, and turning
the Lever Arm the required 80 to 90 degrees.

Tighten the Clamp Bolt ‘E ’.

Fit a 1¼ in. wrench on the Lever Arm Boss and
rotate the Top Lever Arm ‘back’
80 to 90
degrees , against spring pressure .

Refit the Clevis End ‘ C ’.
Shoe Arm Adjustment.
The Guide Shoe Arm must be at a
75 to 80 degree
angle to
the ground.
To adjust the Shoe Arm angle :
Loosen the two Clamp Bolts in the Mounting Pivot.

Tighten the Release Bolt to ‘open up’ the clamp
and rotate the Shoe Arm to the correct angle.

Back-off the Release Bolt and tighten the Clamp
Bolts.
OPERATION
4-12