Brother RH-9820, Инструкция по эксплуатации

Страница: 15 / 134

3. INSTALLATION
RH-9820
6
3-1-2. When embedding into the table
When embedding the machine head into the table, some extra components will be required, so contact the place of purchase
for further details.
NOTE:
When embedding the machine head into the table, be sure to install the L-shaped table reinforcement plates. (Refer to “3-3.
Installing the table reinforcement plates (embedded installation only)”.)
If the table is more than 50 mm thick, the square neck bolts
will not be long enough, so hollow out the underside of the
table to a diameter of 26 mm so that the thickness is 40
mm.
For control box
4 x 4 mm dia.
20 depth
(From underneath
table)
For valve unit
For cotton stand
For pneumatic unit
Shaded area should
be C10
For table leg
Melamine veneer panel
2x 2mm dia. 10 depth
(from underneath
table)
For power switch
For operation panel
4 x 2 mm dia. 10 depth
For operation panel cord
For bed support plate
For L-shaped reinforcement plates
1595B
1594B