III- 30
(5) Set the two head springs L on the bosses of the head ASSY, and assemble the head
ASSY onto the mecha ASSY as shown in the figure.
Note1: Confirm that the head ASSY moves smoothly
Note2: Confirm that the head springs L are properly inserted into the upper and lower
bosses.
Caution: Pay attention not to give strong impact on the heating element of a head
ASSY when mounting the head ASSY.
Fig.3.2-5 Reassembling of the Mecha ASSY (5)
Head ASSY
Bosses
Head ASSY
Insert the head springs L properly
into the bosses of the head ASSY.
Insert the head springs L properly
into the bosses of the mecha ASSY.
Heating element
Hook the left and right arms of the
head ASSY on the release shaft.
Release shaft
Release shaft
Head springs L
1
2
2
3
3
4
4
5
Содержание QL 570 - P-Touch B/W Direct Thermal Printer
