Brother NV1250D, Руководство по эксплуатации

Страница: 37 / 212

Upper Threading 35
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
z
If the needle was not completely threaded,
but a loop in the thread was formed in the
eye of the needle, carefully pull the loop
through the eye of the needle to pull out the
end of the thread.
CAUTION
e
Raise the presser foot lever, pass the end of the
thread through the presser foot, and then pull
out about 5 cm (2 inches) of thread toward the
rear of the machine.
a 5 cm (2 inches)
X
The upper threading is finished.
Now that the upper threading and the lower
threading are finished, you are ready to
begin sewing.
Note
z
If the needle is not raised, the needle
threader cannot thread the needle. Be sure
to press
(“Needle Position” button) to
raise the needle before using the needle
threader.
Threading the needle manually
(without using the needle threader)
When using specialty thread, such as transparent
nylon thread or metallic thread, a wing needle or a
twin needle which cannot be used with the needle
threader, thread the needle as described below.
a
Thread the machine to the needle bar thread
guide.
• For details, refer to “Upper Threading” (page
31).
b
Lower the presser foot lever.
a Pressor foot lever
c
Pass the thread through the eye of the needle
from front to back.
CAUTION
d
Raise the presser foot lever, pass the end of the
thread through the presser foot, and then pull
out about 5 cm (2 inches) of thread toward the
rear of the machine.
●
When pulling out the thread, do not pull
it with extreme force, otherwise the
needle may break or bend.
b
Do not touch the (“Start/Stop”
button), (“Needle Position” button)
or (“Reverse/Reinforcement stitch”
button). If one of the buttons is
accidentally pressed, the machine will
begin sewing and your finger may be
pricked with the needle or the needle
may break.
1