Brother MFC 1870MC, Руководство по обслуживанию, Страница: 66 / 217

IV –
22
(8) To take out the LCD, remove the control panel PCB and the FPC key in step (6). As
shown below, insert the tip of a flat screwdriver under clamp "D" in the direction of arrow
F and push up clamp "D" slightly to release the LCD from clamp "C." In the same way,
insert the screwdriver under clamp "A" to release the LCD from clamp "B."
Then push out the LCD with your fingers in the direction of arrow R.
LCD
R
"B"
F
"A"
(Rear)
Flat screwdriver
F
"C"
R
"D"
■
Reassembling Notes
• To put the LCD back into place, insert the tip of a flat screwdriver under clamp "D" (see
the above illustration) in the direction of arrow R, push up clamp "D" slightly, and then put
the right edge of the LCD under clamp "D." In the same way, insert the screwdriver under
clamp "A" to put the left edge of the LCD under clamp "A."
Then push the LCD into place with your fingers in the direction of arrow F.
• When handling the LCD, take care not to scratch or damage the panel sheet. Replace it
if scratched or damaged.
• A new LCD is covered with a protection sheet. Before installing it, remove the protection
sheet.
• After connecting the main-panel harness to the control panel PCB, be sure to attach a
new rubber foot on the top of the connector as shown below.
• When setting the panel rear cover onto the control panel, pass the main-panel harness
and main-mike harness (provided on the FAX1570MC/1030/MFC1870MC/1970MC)
through the cutout provided in the panel rear cover.
(Side view)
The edge of the rubber foot should not protrude
from this edge of the connector housing.
Align this edge of a rubber foot
with the edge of the connector
housing.
Should be flush.
Rubber foot
Rubber foot
(Top view)