Brother HL-600 Series, Руководство пользователя

Страница: 33 / 84

CHAPTER 3 CONTROL PANEL
3–7
Reset/Hex Dump Mode
The printer has a reset/hex dump mode where you can select and perform
any of three resets or a hex dump print. Follow these steps:
1. Press the SELECT switch to turn the printer off-line.
2. Hold down the SELECT switch and press the FF/CONT switch.
The printer enters the reset/hex dump mode. The ALARM lamp
blinks to indicate that the first choice, User Reset 1, is selected. See
the table below.
3. Press the FF/CONT switch to select another choice.
Every time you press the switch, the blinking lamp changes to select a
choice. See the table below.
4. Press the SELECT switch to perform the selected choice.
Blinking Lamp Choice Function
ALARM User Reset 1 The printer is restored to the
user default settings without
clearing permanent fonts and
macros. You can execute this
by long-pushing the RESET
switch.
READY User Reset 2 The printer is restored to the
user default settings and
permanent fonts and macros
are cleared.
DATA Factory Reset The printer is restored to the
factory settings and
permanent fonts and macros
are cleared.
MANUAL Hex Dump Print The printer can print data as
hexadecimal values, so that
you can check data errors and
problems. To exit from this
mode, you have to reset the
printer.
After resetting, the printer returns to the ready status.
✒
Note
User settings are the printer settings that you change with the remote
printer console program. See the software setup guide for details.