Brother HL-2600CN Series, Руководство по обслуживанию

Страница: 284 / 385

VII-72
23) Remove the E rings (1 pc.) to remove the (gear A) from the fusing unit.
24) Remove the E rings (1 pc.) to remove the (gear B) from the fusing unit.
25) Remove the E rings (1 pc.) to remove the (gear C) from the fusing unit.
26) Remove the E rings (1 pc.) to remove the (gear D) from the fusing unit.
27) Remove the E ring (1 pc.) to remove the (shaft).
Fig.7-103
PRECAUTION
x
Do not touch the surface of the heater lamp with your hands, the small traces of oil
you leave on the lamp will affect the life of the lamp.
x
The wattage of the heater lamp is different between the fuser roller and the back-up
roller. The wattage is marked on the insulator of the lamp electrode.
Fuser roller: 560W
Back-up roller : 420W
Note:
When installing the new fusing unit into the printer, you have to wait approximately for 30
minutes after the unit is installed to allow the fusing oil to circulate in the unit.
(gear A)
(gear B)
E ring
E ring
E ring
E ring
E ring (gear C)
(gear D)
(shaft)