HE-8000
5. OPERATION
44
4. Use the parameter keys (15) and (16) to change
the setting for the selected parameter. (Example:
Buttonhole (round) setting value - 3.)
(When you press the ENTER key (17), the
parameter setting will be changed and the
parameter display LED (14) will stop flashing. The
setting will not be changed if the ENTER key (17)
is not pressed.)
5. Repeat steps 3 and 4 to change other parameter
settings.
Checking the length of knife
Use the program No. keys (7) and (8) to select
parameter No. 02.
(Parameter No. 02 is used to set the length of the
knife.)
Check that the length of the knife which is has
been installed is the same as the length setting
which appears in the parameter display LED (14).
If the values are different, use the parameter keys
(15) and (16) to change the parameter setting
value so that it is the same as the length of the
knife, and then press the ENTER key (17).
(The length of the knife has now been set.)
NOTE:
Be sure to change the knife length setting if the
knife is replaced with a knife of a different
length.
The stitch length will be automatically determin-
ed by the value for the length of the knife which
has been set. Therefore, if the knife length is
not set correctly, problems may occur, such as
the bar tacking stitches being cut by the knife.
6. Press the SELECT key (13) to change the mode
to automatic mode.
* A round buttonhole sewing pattern has now
been set for program No. 03.
* The setting details can be saved in the pro-
gram notes of the program memos for easy
checking.
(14)
(15)
(16)
(17)
2115Q
(14)
(15)
(16)
(8)
(7)
(17)
2116Q
(13)
2117Q
