Brother DreamWeaver XE VM6200D, Руководство по эксплуатации

Страница: 144 / 324

SEWING THE STITCHES
S-56
c
Attach button sewing foot “M”, slide the
button along the metal plate and into the
presser foot, and lower the presser foot.
a
Button
b Metal plate
d
Rotate the handwheel toward you
(counterclockwise) to check that the needle
goes into each hole correctly.
* If the needle does not reach the holes on the left
side, adjust the stitch width.
* To attach the button more securely, repeat the
process.
e
Gently hold the end of the upper thread and
start sewing.
→
The machine stops automatically when sewing is
finished.
f
From the wrong side of the fabric, pull the
end of the bobbin thread to pull the upper
thread through to the wrong side of the
fabric. Tie the two thread ends together and
cut the threads.
g
After the button is attached, select another
stitch and rotate the handwheel toward you
(counterclockwise) to raise the feed dogs.
■
Attaching 4 Hole Buttons
Sew the two holes closest to you. Then raise the
presser foot and move the fabric so that the needle
goes into the next two holes, and sew them in the
same way.
■
Attaching a Shank to the Button
a
Pull the shank lever toward you before
sewing.
a Shank lever
b
Pull the two ends of the upper thread
between the button and the fabric, wind
them around the shank, and then tie them
firmly together.
c
Tie the ends of the bobbin thread from the
beginning and end of sewing together on
the wrong side of the fabric.
d
Cut off any excess thread.
CAUTION
• Make sure the needle does not strike the
button during sewing. The needle may break
and cause injury.
Note
• When sewing is completed, be sure to
select the other stitch and rotate the
handwheel toward you (counterclockwise)
to raise the feed dogs.