Programmer
107
Chapter 3 Programming with Command Function
Creating double stitch
Command to be used
M
2
Creating double stitch in the reverse direction to the sewing
path. Input the width of double stitch in
.
Values 0.0 - 9.9 mm are available for the width.
Example
Width
Input
1.5 mm
215
M
Input the stitch length in
.
L
7
8
9
Input the point to be a corner.
Carrying out double stitch on the left side to the sewing path.
E
1
1
1
Starting double stitch calculations.
If sharp angles or fine curves are included in the pattern sheet, the desired double stitch may
not be achieved.
1.
Select the sewing start position with
, then press
L
.
2.
Determine the width, then input
M
2
.
To change the stitch length, input it after this procedure.
3.
Move the needle with
to select the second point, then press
L
.
4.
Move the needle to the corner point, then input
L
7
8
9
.
Displays the number of the command input.
Displays the number of the command input.
Содержание BAS-761
