8. LIST OF ERROR CODES
BAS-341H, BAS-342H
52
Motor-related errors
Code
Cause of error and remedy
E110
The needle bar is not stopped in the needle up stop position.
Turn the pulley until the point where the error display disappears.
E111
Upper shaft did not stop at the needle up stop position when the sewing machine stopped.
Turn off the power, and then check that connectors P11 and P1 on the motor P.C. board and connector P6 on the
main P.C. board are properly inserted.
E121
Thread trimming was not completed.
Turn off the power, and then check if the cutting edges of the fixed knife and movable knife are damaged or worn.
E130
Upper shaft motor stopped due to a problem, or synchronizer is faulty.
Turn off the power, and then turn the pulley and check if the sewing machine has locked up. Check that
connectors P11 and P1 on the motor P.C. board, connector P6 on the main P.C. board and the 4-pin connector of
the upper shaft motor on the motor P.C. board
E131
Synchronizer is not connected correctly.
Turn off the power, and then check that connector P11 on the motor P.C. board is properly connected.
E132
Problem detected with upper shaft motor operation.
Turn off the power, and then check that connectors P11 and P1 on the motor P.C. board, connector P6 on the
main P.C. board and the 4-pin connector of the upper shaft motor on the motor P.C. board are properly inserted.
E133
Upper shaft motor stopping position is incorrect.
Turn off the power, and then check that connectors P11 and P1 on the motor P.C. board, connector P6 on the
main P.C. board and the 4-pin connector of the upper shaft motor on the motor P.C. board are properly inserted.
E150
Upper shaft motor is overheating, or temperature sensor is faulty.
Turn off the power, and then check the upper shaft motor.
(When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle
operation), the upper shaft motor may overheat and the “E150” error code may be generated.)