Troubleshooting
A-14
■
While sewing
The sewing light
does not come on.
The sewing light is damaged.
Contact your authorized Brother dealer or the
nearest Brother authorized service center.
–
“Light” is set to “OFF” in the settings screen.
Change the setting to “ON”.
B-15
Embroidery unit
does not operate.
Embroidery unit is not attached correctly.
Reattach the embroidery unit correctly.
B-54
Embroidery frame was attached before the unit
was initialized.
Remove the embroidery frame, and then
perform the initialization process correctly.
B-55
Symptom
Probable Cause
Remedy
Reference
Machine does not
operate.
“Start/Stop” button was not pressed.
Press the “Start/Stop” button.
B-35
The bobbin winder shaft is pushed to the right.
Move the bobbin winder shaft to the left.
B-18
There is no pattern selected.
Select a pattern.
B-35
Presser foot is not lowered.
Lower the presser foot.
B-2
“Start/Stop” button was pressed with the foot
controller attached.
Remove the foot controller, or use the foot
controller to operate the machine.
B-37
The “Start/Stop” button was pressed while the
machine is set for the sewing speed controller
to control the zigzag stitch width.
Use the foot controller instead of the “Start/
Stop” button to operate the machine, or set the
“Width Control” to “OFF” in the settings screen.
B-13
Needle breaks.
Needle is installed incorrectly.
Reinstall the needle correctly.
B-31
Needle clamp screw is not tightened.
Tighten the needle clamp screw.
B-31
Needle is turned or bent.
Replace the needle.
B-31
Using improper needle or thread for the
selected fabric.
Check the “Fabric/thread/needle combinations”
chart.
B-30
Wrong presser foot was used.
Use the recommended presser foot.
B-34
Upper thread tension is too tight.
Adjust the thread tension.
B-41
Fabric is pulled during sewing.
Do not pull the fabric during sewing.
–
Spool cap is set incorrectly.
Check the method for attaching the spool cap,
then reattach the spool cap.
B-18
There are scratches around the opening in the
needle plate.
Replace the needle plate, or consult your
authorized Brother dealer.
A-8
There are scratches around the opening in the
presser foot.
Replace the presser foot, or consult your
authorized Brother dealer.
B-33
There are scratches on the bobbin case.
Replace the bobbin case, or consult your
authorized Brother dealer.
A-2
Needle is defective.
Replace the needle.
B-31
A bobbin designed specifically for this machine
is not used.
Incorrect bobbins will not work properly. Only
use a bobbin designed specifically for this
machine.
B-18
Upper threading is incorrect.
Check the steps for threading the machine and
rethread the machine.
B-24
Bobbin is set incorrectly.
Reset the bobbin correctly.
B-21
Presser foot is attached incorrectly.
Attach the presser foot correctly.
B-33
Screw of the presser foot holder is loose.
Securely tighten the screw of the presser foot.
B-34
Fabric is too thick.
Use fabric that the needle can pierce when the
handwheel is turned.
B-30, S-4
Symptom
Probable Cause
Remedy
Reference
Содержание 888-G00
Страница 2: ......
Страница 76: ...Embroidering B 66 ...
Страница 122: ...Decorative Stitching S 46 ...
Страница 182: ...Using the Memory Function E 36 ...