200768_1
21
Servicing Instructions
Servicing should be carried out annually by a qualified installation gas safe engineer.
To open the door, remove the handle by rotating it anti-clockwise until it clears the
thread. The handle acts like a nut on a thread and once removed will allow the door
to open fully.
Remove the logs and clean any dust and debris from the top of the burner unit and
the inside of the stove. A vacuum cleaner can be used, but take care around the pilot
assembly to prevent accidental damage. A clean soft brush can also be used. Take
care not to brush any debris towards the pilot as this may cause an obstruction in the
jet.
Clean any dust / debris from each individual ceramic using a very soft brush.
Check the condition of the ceramics. Damaged ceramics will affect the efficient
operation of the stove and will need to be replaced.
Clean the glass with a soft cloth.
The outside of the stove can be cleaned as per instructions given previously.
Re-lay the ceramics and close the door ensuring an air tight seal.
Ignite the appliance and observe an even flame pattern.
Carry out all necessary final checks and leave the appliance in a fully commissioned
state.
Commissioning Form
