200768_1
17
Operating the Stove
It is important to read these instructions thoroughly before lighting the stove.
The gas stove operates with a traditional permanent pilot light.
The knob for ignition and power control are located on the lower right hand side of the
stove, the indicator in the plate shows the knob position (Marked on knob)
The pilot light is located at the front left corner of the main ceramic.
If the Flame Supervision Device Actuating Flame (the pilot light) is extinguished by
intention or not, no attempt should be made to re-light
until 3 minutes have elapsed.
IGNITING THE PILOT AND USING THE HIGH/LOW FUNCTION
1. From the start position, depress the control knob fully.
2. Whilst depressed, turn knob sharply 90 degrees anti-clockwise to “pilot” setting.
You should feel some resistance and hear a click. Repeat until pilot light is
visibly lit. You should be able to see the spark from the electrode and once lit the
pilot flame via the small hole in the main ceramic base.
3. Keep knob depressed at this point for 15-20 seconds, then release.
4.
Upon releasing, ensure the pilot is still lit, if not, repeat above steps.
5.
With pilot established, turn the knob Anti-clockwise to select the low flame
setting. Turning the control further anti-clockwise you will be able to select the
high flame setting.
6.
From the high setting you can select low by turning the control knob clockwise.
EXTINGUISHING THE STOVE FULLY
1. From any heat setting, or the permanent pilot, depress control knob and turn
clockwise to “OFF” position.
