27
2.1.10. VERSALLES
D40
Versalles-C
In order to install the Versalles-C series, a metallic Z-shaped piece is provided, that you have to
screw on the wall and will support all the weight (
see drawing D40
).
IMPORTANT!!!: it is necessary to assure that the wall will support the weight of the fireplace (and the weight of the wood).
It is not recommended to install the fireplace on walls made of materials that are not able to support the weight or made of
combustible materials.
Outdoor air intake
In the models of the Versalles series, it is possible to choose that the entrance of primary air comes from a contiguous place or even from
outside of the house.
In the case of providing air from outside or from a contiguous place, you must purchase the optional kit (KIT-AIR2) for external air intake
(airtight). Simply connect the KIT with a 100 mm diameter pipe to the chosen place. Keep in mind that a too long pipe or with too many
deviations (elbows), far from benefiting the intake of air, causes a great loss of load and, therefore, can cause combustion problems.
Do not forget that this external air intake is independent and different from the input needed for the ventilation unit (turbine).
The procedure for placing the optional external air intake kit is as follows (
see drawing D41
):
-
At the bottom, under the top, you will find 4 screws that are threaded.
-
Remove the 4 screws.
-
Place the kit as shown in the drawing.
-
Replace the 4 screws previously removed.
-
Connect the air intake to the exterior or selected environment through a 100 mm diameter pipe.
D41
2.1.11.
MODEL FÍGARO
D42
In this model, the inside of the oven is made of two pieces made in stainless steel (upper and
lower) which can be disassembled for an easy cleaning.
In order to disassemble them, you should follow the next steps (
see drawing D42
):
1.
First, remove the upper piece by unscrewing two screws on the left side and two screws
in the right side.
2.
Remove the lower piece, by unscrewing the screws placed on the left and right side.
D43
In order to open the door of the combustion chamber, it is necessary to press downwards the small handle
placed in the right side (
see drawing D43
).
D44
The door has a self-closing device and along the use it may lose effectiveness.
To adjust the automatic closing of the door, it is necessary to adjust the regulator
placed in the back part of the model. Note, that when you turn this regulator
clockwise, the spring receives more tension and the door lock is easier (
see
drawing D44
).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
STOVES
EN
