BRONKHORST ES-FLOW 1 C Series, Инструкция по эксплуатации

Страница: 34 / 41

Bronkhorst®
Instruction Manual ES-FLOW™ 1xxC 9.17.153A 34
Wink
Type Access Range FlowDDE FLOW-BUS Modbus
Unsigned char [27] W 0…9* 1 0/0 0x0000/1
Sending any text string value between 1 and 9 to this parameter makes the indication LEDs (if present) blink for a couple of
seconds. This can be useful in order to identify a specific device in a large fieldbus network.
*) Modbus only supports value 14592
Control Mode
Type Access Range FlowDDE FLOW-BUS Modbus
Unsigned char RW 0…255 12 115/1 0x0024/37
Control Mode is used to select different control modes of the instrument and determines from which source(s) it accepts a
setpoint. The following control modes are available:
Value Mode Instrument action Setpoint source
0 BUS/RS232 Controlling Fieldbus/RS-232
1 Analog Input Controlling Analog input
2 FLOW-BUS Slave Acting as slave instrument on FLOW-BUS RS-485 only: FLOW-BUS
master output x Slave
Factor/ 100%
3 Valve Close Controller disabled, valve closed
4 Controller Idle Controller disabled, valve frozen in current position
7 Setpoint 100% Controlling, setpoint fixed to 100%
8 Valve Fully Open Controller disabled, valve fully opened
9 Calibration Mode Calibration mode enabled
(factory only)
10 Analog Slave Acting as slave of other instrument in analog mode Analog Input x Slave
Factor/ 100%
12 Setpoint 0% Controlling, setpoint fixed to 0%
13 FLOW-BUS
Analog Slave
Acting as slave of other instrument on FLOW-BUS, slave
factor is set by analog input signal
RS-485 only: FLOW-BUS
master output x Analog Input
18 RS232 Controlling, safe state deactivated Fieldbus/RS-232
20 Valve Steering Controller disabled, setpoint redirected to Valve output
21 Analog Valve
Steering
Controller disabled, analog input redirected to Valve output
22 Valve Safe State Force instrument in safe state
Immediately after power-up, Control Mode is set to 'Analog input’ or ‘BUS/RS232’ automatically, depending on the (requested)
default setting for analog or digital operation. If Control mode is set to value 0, 1, 9 or 18, the instrument returns to its
default control mode at the next power-up or reset. Other values are retained after power-up or reset.
Calibration Mode
Type Access Range FlowDDE FLOW-BUS Modbus
Unsigned char RW B 0, 9, 255 58 1/4 0x0E61/3682
After enabling calibration mode by means of parameter Control Mode , this parameter is used to start the autozero function
of the flow sensor. The following modes are supported:
Value Description
0 Idle (no action)
9 Start zeroing
255 Error (result of previous calibration mode)