brondell DS725 Series, Руководство пользователя

Страница: 27 / 88

25
Problem Possible Cause(s) Solution(s)
Nozzle does not
function properly 1. Nozzle is dirty
2. Clogged filter
3. Water pressure is too low
4. External bidet filter
1. Clean nozzle (see Page 22).
2. Remove, clean, and reinstall mesh filter
(see Page 23).
3. Check water supply valve at wall is
fully open.
4. If you have an external bidet filter, check
and replace if necessary.
Water Temperature
is low 1. Water comes out cold
2. Water comes out lukewarm
3. Water starts out hot but decreased
in temperature
1. The Water temperature level is turned
off or set to “LOW”. Adjust temperature on
control panel.
2. Turn off Eco Mode.
3. Warm water can be used for about 40
seconds at the “MEDIUM” setting. Stop all
wash functions to allow the heater to warm
the water.
Seat is not heated 1. Seat temperature set to off 1. Make sure that the Seat temperature
setting is on.
Bidet wash feature
does not work or
fails to spray 1. Body sensor does not detect that you
are sitting on the Swash 1a. Adjust sitting position to fully cover the
Body Sensor (see Page 8).
1b. Override the body sensor – refer to
Special Mode Operation section on Page 20
to unlock the body Seat Sensor.
Water (wash spray)
not heated 1. Water temperature set to off
2. Resettable fuse blown
1. Make sure that the Water temperature
setting is on.
2. The bimetal resettable fuse may blow if
the temperature exceeds over the normal
level. The bidet will not work and show an
error message until the bidet cools down.
Water flows before
or after use 1. Water coming from nozzle 1a. The water that comes out between the
nozzle before or after a wash cycle is the
self-clean cycle and is not a malfunction.
1b. Residual water may drip into the bowl for
several seconds after a wash cycle or
self-clean cycle, and is not a malfunction.