Broderson IC-35-2G, Руководство по эксплуатации и обслуживанию, Страница: 15 / 71

1-11
Downhaul and Sheave Block:
Includes downhaul weight and hook for single part line. Downhaul and hook
assembly weight is 40 pounds (18 kg). Downhaul is designed to clamp dead
end of rope. Also includes sheave block for two-parting line for lifts over
4000 pounds (1800 kg). 7-inch (18 cm) OD sheave is grooved for 3/8-inch
(10 mm) wire rope. Sheave block weight is 60 pounds (27 kg). Both
attachments are specially designed to actuate the Anti-Two-Block system.
Rated Capacity Limiter:
Operator's aid that warns operator of impending overload with audible and
visual signals. Has read-outs for load, boom angle, boom length and load
radius. In the event of an overload, dumps the following boom functions:
HOIST RAISE, TELESCOPE EXTEND, BOOM LOWER, SWING LEFT, and
SWING RIGHT. These circuits are returned to normal by lowering load to a
safe resting place with hoist or by retracting or raising boom to a shorter load
radius. Key-operated, momentary override switch located under dashboard.
Optional Boom Attachments:
Boom Extension, 8-Foot (2.4 m):
Provides 8 feet (2.4 m) of additional length for lifting loads with load line.
Boom extension may be stowed along side base boom section when not in
use. Tip sheave, attaching brackets, and pins included. Deduct 100
pounds (45 kg) from Capacity Chart when boom extension is in stowed
position. Includes switch and trip arm for Anti-Two-Block system.
Net Weight: 130 pounds (59 kg)
Boom Extension, 8-Foot (2.4 m) Offset:
Same as standard boom extension, except has three settings: 0 degrees (in-
line), 15 degrees offset, and 30 degrees offset.
Net Weight: 150 pounds (68 kg)
Searcher Hook:
2000-pound (907 kg) capacity. Swivel hook with spring latch hangs from
support structure, projecting outward from boom tip.
Net Weight: 30 pounds (14 kg)
Specifications subject to change without notice.