Brocade Communications Systems Brocade 8/12c, Справочник по командам

Страница: 1070 / 1132

1036 Fabric OS Command Reference
53-1001764-01
turboRamTest
22
turboRamTest
Performs a turbo SRAM test of ASIC chips.
SYNOPSIS
turboramtest
[ --slot slot ]
[ -passcnt count ]
ceeturboramtest
[ --slot slot ]
[ -passcnt count ]
DESCRIPTION
Use this command to verify the chip SRAM located in the ASIC using the turbo-RAM BIST circuitry. The
BIST controller is able to perform the SRAM write and read operation at a much faster rate than the PCI
operation.
The turboRamTest and ceeTurboRamTest commands are platform-specific versions of the same test.
The turboRamTest command is supported on all Goldeneye2 and Condor-based platforms. Use
ceeTurboRamTest on FCoE platforms only. On all other supported platforms, use turboramtest . Refer
to the Fabric OS Troubleshooting and Diagnostics Guide , Appendix A, for a table that correlates ASIC
type with switch models.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
The switch must be disabled before you can run this diagnostics.
OPERANDS
This command has the following optional operands:
--slot slot
Specifies the slot number on which the diagnostic operates. All eligible blade ports
in the specified slot are tested. This operand is optional. The default value is 0 and
operates on fixed port count products.
-passcnt count
Specifies the number of times to perform this test. This operand is optional. The
default value is 1.
EXAMPLES
To run the SRAM test with two passes:
switch:admin> turboramtest -passcnt 2
Running turboramtest ..............
PASSED.
To run the SRAM test on a Brocade 8000 in default mode:
switch:admin> turboramtest
Running turboramtest ..............
PASSED.
SEE ALSO
None