Broan ERV100S, Руководство по установке

Страница: 14 / 24

14
3. CONTROLS (
CONT
'
D
)
3.3 ERV100S U
NIT
I
NTEGRATED
C
ONTROL
LED C
OLOR
R
ESULTS
AMBER U
NIT IS ON
L
OW
S
PEED
GREEN U
NIT IS ON
H
IGH
S
PEED
N
O
L
IGHT
U
NIT IS
OFF
OR CONTROLLED BY A MAIN CONTROL
Use the push button ( 2 ) to control the unit. The LED ( 1 ) will then
shows on which mode the unit is in. Refer to table at right.
NOTE: When using main control, the integrated control
must be turned off.
3.4 S
ETTING
E
XTENDED
D
EFROST FOR
ERV100S
UNIT
These units are factory set to normal defrost. In cold region (outdoor temperature -17°F
and lower), it may be necessary to setup extended defrost. During the first 3 seconds of
booting sequence, the integrated control LED shows the current defrost mode (refer to
table at right).
LED C
OLOR
D
EFROST
M
ODE
GREEN N
ORMAL
AMBER E
XTENDED
Within the first 3 seconds of booting sequence, press on push button until the LED starts to blink, then release the push button; the
LED will blink AMBER 5 times. After that, the LED will shut off, then turn RED (the unit returns in its booting sequence).
NOTE: There is a 15-minute delay for the new defrost cycle choice to be kept in memory; if a power failure occurs during this time
delay, when the power returns, the unit resume to its previous setting.
3.2 ERV100SP U
NIT
I
NTEGRATED
D
EFROST
C
ONTROL
After the booting sequence is done, the LED ( 1 ) will light and stay lit to show in which defrost
cycle the unit is set. Use the push button ( 2 ) to change the defrost cycle of the unit (see table
at right).
LED C
OLOR
D
EFROST
C
YCLE
GREEN S
TANDARD
RED P
LUS
AMBER D
ISCRETION
According to your needs, there are 3 defrost cycles available:
STANDARD: This is the factory set defrost cycle. Being the most energy recovery efficient defrost cycle available on this unit,
STANDARD is used to achieve HVI and ENERGY STAR
®
listed performance. When needed, the unit will perform
defrost cycle on high speed.
PLUS: This mode has been created for people who live in cold region (outdoor temperature -17°F and lower). This setting
makes the unit perform defrost cycle on high speed for a longer period of time.
DISCRETION: When needed, the defrost cycle will be performed on the same speed than the unit ventilation speed. This means
that if the unit is set on high speed, the defrost cycle will be done on high speed, but if the unit is set on low speed,
the defrost cycle will be done on low speed.