1
MODEL HCR4
1105180A
1 - Turn range hood on. Within a 15-second period, press and hold the POWER ON/OFF button on the hood for 5 seconds. Buttons
backlighting will flash. Press each button on the remote control one after the other to pair the remote control with the hood.
2 - Use the remote control as follows:
- Press the LIGHT BUTTON to turn the lights on at high intensity. The backlight of the button will turn on.
- Press the LIGHT BUTTON again to turn the lights on at low intensity.
- Press the LIGHT BUTTON once again to turn the lights off. The backlight of the button will turn off.
- Press the UP BUTTON to turn the blower on at low speed. The backlight of the button will turn on. The LED display shows “1”.
- Press the UP BUTTON again to turn the blower on at medium/low speed. The LED display shows “2”.
- Press the UP BUTTON once again to turn the blower on at medium/high speed. The LED display shows “3”.
- Press the UP BUTTON another time to turn the blower on at high speed. The LED display shows “4” (only available with 600
CFM setting).
- Press the DOWN BUTTON to decrease blower speed. The backlight of the button will turn on. The LED will display current
speed. When the blower is set at low speed (LED display showing “1”), pressing another time the DOWN BUTTON will turn the
blower off as well as the backlight of the button.
- Press the 15-MIN DELAY BUTTON while the blower is on to activate the delay function. The backlight of the button will turn
on. The hood will run for 15 minutes. Once the 15-minute period elapsed, the blower and lights will turn off automatically.
- To cancel the delay function before the end of the 15-minute period, press another time the 15-MIN DELAY BUTTON or
change the blower speed using the UP BUTTON or the DOWN BUTTON. The backlight of the 15-MIN DELAY BUTTON will
turn off.
3 - If the remote control is not working, try to pair it again with the hood. Perform the following steps:
- Press and hold the POWER ON/OFF button on the hood for 5 seconds. Buttons backlighting will flash.
- Press and hold the POWER ON/OFF button on the hood for 5 seconds another time. The hood is not paired anymore with the
remote control.
- Perform step 1.
H
OW
TO
U
SE
R
EMOTE
C
ONTROL
L
IGHT
BUTTON
15-
MIN
DELAY
BUTTON
U
P
BUTTON
D
OWN
BUTTON
⚠
WARNING
C
HEMICAL
B
URN
H
AZARD
Keep batteries away from children.
The remote control requires a 3 V lithium button cell type CR2025.
This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body,
it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If
the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you
think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
a)
The cells shall be disposed of properly, including keeping them away from children; and
b)
Even used cells may cause injury.
